Configuring the pedals/wheels/knobs

You can specify the pedal functions and pedal type.

1.Tap the “Pedal and others” button.

p28.2

2.Specify the settings below.

Pitch Bend Range

You can set the range of the pitch bend to a value between 0 and 24.
Tap “+” or “-” to adjust.
Tap the “reset” button to restore the default settings.

Assignable functions to Damper pedal

This allows you to configure the damper pedal functions.
Choose from the options below.

Damper: Pressing the pedal while playing will apply sustained reverberation even after the key is released. On an instrument such as an organ where the tone of a note is sustained for as long as the key is pressed, note will continue to sound while the pedal is pressed.

Sostenuto: Sustained reverberation is applied just to the keyboard sound when the pedal is pressed and is maintained until the pedal is released, even if the key is released.

Soft: While the pedal is pressed, the volume of the note struck is reduced slightly and an effect is achieved that makes the sound appear softer.

Tempo Setting: Pressing the pedal two or more times sets the tempo based on the interval between the pedal movements.

Metronome: Allows you to start and stop the metronome by pressing the pedal.

Tap Tempo: Pressing the pedal two or more times sets the tempo based on the interval between the pedal movements.

Arpeggio Hold: When the Arpeggiator function is enabled, this enables arpeggio hold while the pedal is pressed.

Play/Stop: Functions in the same way as START/STOP.

Fill-in: If the pedal is pressed while accompaniment is playing, fill-in is played.

Expression/Assignable Input: Pedal Types

SW: Select when a switching pedal (Casio sustain pedal) is connected.

Exp.Type1: Select when a polarity type 1 expression pedal is connected.

pianoRC-ver.2_Pedal_ExpType1

Exp.Type2: Select when a polarity type 2 expression pedal is connected.

pianoRC-ver.2_Pedal_ExpType2

Expression/Assignable Input: Pedal Functions

Expression: Controls the expression (MIDI Control Change No.11).

Master Volume: Controls the volume.

Tempo: Controls the tempo.

Layer Balance: Controls the volume balance between the Upper1 and Upper2 parts.

Sustain: Pressing the pedal while playing will apply sustained reverberation even after the key is released. On an instrument such as an organ where the tone of a note is sustained for as long as the key is pressed, note will continue to sound while the pedal is pressed.

Soft: While the pedal is pressed, the volume of the note struck is reduced slightly and an effect is achieved that makes the sound appear softer.

Sostenuto: Sustained reverberation is applied just to the keyboard sound when the pedal is pressed and is maintained until the pedal is released, even if the key is released.

Arpeggio Hold: When the Arpeggiator function is enabled, this enables arpeggio hold while the pedal is pressed.

Play/Stop: Functions in the same way as START/STOP.

Fill-in: If the pedal is pressed while accompaniment is playing, fill-in is played.

Speaker Out

Set the output from the speaker.

For CDP-S90/CDP-S100/CDP-S105/CDP-S110/CDP-S150/CDP-S160/CDP-S350/CDP-S360/PX-S1000/PX-S3000:

Set ON/OFF.

For PX-S1100/PX-S3100:

Set Auto/ON/OFF.

Knob: Assignable

You can specify the knob function.