Configuring effects

You can use effect functions to change the resonance and depth of the sound.

1.Tap icon_Ver.2_Effect

2.Specify the settings below.

Sound Mode: Hall Simulator/Reverb

You can enable and disable the hall simulator and reverb.

Hall Simulator/Reverb

The hall simulator and reverb are both types of effect that change the resonance of sound.

Hall Simulator: Simulates the different acoustic characteristics of world-famous concert halls and building interiors, including resonances that are brilliantly clear and pure and those that are colorful and unconstrained.
Use ON/OFF to enable and disable the effect.

  • N.Y.Club: A music club in Manhattan
  • Standard Hall: A standard concert hall
  • Opera Hall: The unique shapes of the Sydney concert hall
  • Berlin Hall: An arena-type classic concert hall in Berlin
  • British Stadium: A large outdoor stadium on the outskirts of London

Reverb: A type of effect that reproduces the spatial resonances inside a room or hall.

  • Room 1, Room 2, Room 3, Large Room (LargeRm 1, LargeRm 2): Reverb that gives the sensation of being indoors
  • Hall 1, Hall 2, Hall 3: Reverb that gives the sensation of being in a small hall
  • Stadium 1, Stadium 2: Reverb that gives the sensation of being in a stadium
  • Virtual Hall: This allows you to achieve the sound effects of performing in a classic concert hall.
  • OFF: Reverb is not used.

Sound Mode: Surround

Allows you to obtain a virtual surround effect. This effect is applied when externally input vocals are played through the speakers of your musical instrument.
Use ON/OFF to enable and disable the effect.

Surround Type

  • Type1
  • Type2

Hall Simulator/Reverb Depth

You can set the intensity of the Hall Simulator/Reverb effect applied to the musical instrument sound source.
Tap the “+” or “-” button to adjust the setting.
Pressing the “reset” button restores the default setting.

Audio In Hall Depth

You can set the intensity of the Hall Simulator/Reverb effect applied to externally input vocals (Bluetooth input or AUDIO IN port input).
Tap the “+” or “-” button to adjust the setting.
Pressing the “reset” button restores the default setting.

Chorus

Chorus is an effect that adds richness and depth by overlaying sound.

Tone: Sets the defaults for each tone.

Chorus 1

Chorus 2

Chorus 3

Chorus 4

FB Chorus

Deep Chorus

Flanger 1

Flanger 2

Flanger 3

Flanger 4

Short Delay 1

Short Delay 2

1: Applies a slight chorus effect.

2: Applies a moderate chorus effect.

3: Applies a strong chorus effect.

4: Applies a flanger (a whooshing effect).

OFF: The chorus effect is not used.

Brilliance

You can adjust the sound brightness to any value between -3 and +3.
Settings of +1 or higher give a sound with a brighter impression, while settings of -1 or less produce a mellower sound.
Tap the “+” or “-” button to adjust the setting.
Pressing the “reset” button restores the default setting.